200 Toyota Tundra Rear Axle Bearing Removal

I used snap ring pliers and a screwdriver.

200 toyota tundra rear axle bearing removal. Lubricate the new rear wheel bearing with the specified lubricant. Posted on Jul 26 2009. A special service tool SST part number 09521-25011 will be needed to remove the rear axle shaft and bearing retainer from the backing plate.

Remove the snapring. Parts like Rear Axle Shaft Hub are shipped directly from authorized Toyota dealers and backed by the manufacturers warranty. Once the seal is seated coat the lips of the seal with grease.

-put drain pan under axle housing-remove rear axle housing cover 10 or 12 bolts-turn gear untiil the bolt for cross shaft shows and remov e the bolt-remove the cross shaft-push axle in until you can remove U clip from axle and axle will pull out Remove seal you need a pulller to remove axle brg. Remove the axle shaft 4234. I recently removed and replaced a rear left bearing on my 2008 Toyota Tundra 47 Limited at 73k and noticed something loose where the shaft would eventually be re-inserted.

Rear Wheel Bearing and Axle Shaft Oil Seal Removal. Fits Tundra Axle Shaft - Repair or ReplaceThe Axle Shaft in your Toyota may need to be removed to replace a seal or bearing because of a leak or noise. There is a TSB on it as well T-SB-0297-10.

Parts like Rear Axle Housing Differential are shipped directly from authorized Toyota dealers and backed by the manufacturers warranty. Our Toyota technicians have Access to all the OEM parts and follow factory. Hub bearing assembly rear axle left.

Also it will fit any symmetrical 4-bolt. I read a few different stories of people replacing everything - seals. Parts fit for the following vehicle options.