2000 Toyota Tundra Ignition Switch Removal

Secure the switch with its screws.

2000 toyota tundra ignition switch removal. It doesnt idle anymore. You can switch ignition coil to the other cylinder to check if the misfire follows that pack. It did exactally what I wanted it to when.

The ignition switch is an often-overlooked but essential part of nearly any automobile. Within 40 seconds close and open the drivers door twice. Detach the illumination ring by pulling out the plastic pin on the side.

One was a starter relay in the fuse box. Remove the lower steering column cover. So watch and see how Allen helpe.

Auto trans from 1199 moon mist. My Tundra has had not had this issue in 280k miles so I can only speak to other vehicles I have owned that had this issue. Make sure both the lock cylinder and column lock are in the ACC position.

Replacing ignition switch after it got me stranded after a small ice storm we had. Just remove an ignition coil that you know is good with a good spark plug and hook up to the wire were the bad one was. Press the release bottom with this screwdriver as you pull the lock cylinder straight out.

Turn the steering wheel to expose and remove Philips screws on either side to allow removal of lower steering column cover. I have a 2016 Tundra. You need to replace the starter solenoid contacts or the starter itself.