2000 Toyota Tundra Rear Bumper Removal

Find discussions on the Toyota Tundra Diesel TRD Pro SR5 lift kits towing capacity classifieds and more.

2000 toyota tundra rear bumper removal. A Open the bonnet and look for one 13mm nut on the lower inside of each headlight. -we release the latch in the bumper and remove the grille. All the same-as-original bumpers from Replace are a perfect option to go if you want to restore and maintain the original look of your vehicle.

I am going to paint mine this weekend. The hardest part of removing the bumper is getting under the truck and popping the small plastic tabs that hold the black top cover on. Cut two plastic clips 22 and remove harness 23 from rail 24.

Next underneath the bumper there are 2 clips that you need to pull out with a flat head screw driver they point straight to the ground and are holding the bumper extenders in place Then the easy part remove the 14mm bolts 2 on each side attached to the frame. Posted on Jul 20 2009. Its not impossible just a pain.

Then turn it over and undo about a zillion clips with needle nose pliers to take the three top plastic pieces off. Then just jiggle it off. You might have to move the 14 liner over a bit to fond them.

There are a bunch of tabs that you have to pinch inorder to remove the big black plastic piece that runs the width of the bumper. The tongue capacity of 500 lbs is the weight of the hitchball can take from gravity so you can drop 500 lbs onto the. B Remove the towing eye covers on the lower section of the bumper and you will find one 13mm nut in each.

If you wish to remove the entire set up from the frame remove the bolts attaching the brackets to the frame rails. -wrenched the wheel to the left or right side depending on which side we will analyze first. I thought someone posted a pdf on how to remove the front bumper for a 08 Toyota Tundra.