2007 Toyota Tundra Block Heater Location

Location of block heater port on 2010 toyota tundra 57 ltr - Answered by a verified Toyota Mechanic We use cookies to give you the best possible experience on our website.

2007 toyota tundra block heater location. For the 1GR-FE V6 engine 40 Litre the part number for the block heater is PU140-00902. This block heater is a cartridge style heater that does not require you to remove your frost plug or drain the coolant for installation. Immediately behind the driver side exhaust header there is a factory designed hole for the block heater with an electrical connection mounted beneath it.

I have found what I think is one for my truck according to Phillips Temros website zerostat 3100129 but it says its a cartridge type. Its located at the back of the block under the master brake cylinder. I found one install sheet saying that the block heater goes.

The best part is our Toyota Tundra Engine Heaters products start from as little as 3599. Those of you installing freeze plug block heaters proceed to Step 2 and those of you using the heater mount move on to Step 5. THe deal says its a dry typ block heater which is what I wanted.

I have been crawling around in the snow for an hour and I give up. Its not that hard just make sure the engine is cold when you install it the cat is right beside it and gets red hot. The location I THINK is the location is on the drivers side in the engine block just above where the transmission and engine connect.

Location is in the engine bay. Installing kats 11813 engine block heater on 2zr-fe 18l. Who out there has installed one and what type was it cartridge threaded freeze plug.

That is where they are normally. CORE HOLE PLUG LOCATION AND CORDSET ROUTING - Left side rear. The hole for installation is present on all of our motors its as simple as buying the 30 part and spending 30 minutes installing it.