2007 Toyota Tundra Dash Removal

RAM on our dash mount in the desired location.

2007 toyota tundra dash removal. Discussion in 25 Gen Tundras 2014-2021 started by. We are nation wide with chapters in most states. Remove the three bolts four nuts and instrument panel reinforcement bar assembly.

Lift up at the latch hole the entire thing up to the dash will lift up. Remove the blend door actuator from the vehicle. Pull the dash toward you starting at the bottom corner to the right of the steering wheel until the corner comes free exposing the panel below the climate controls.

RADIO REMOVAL DASH SPEAKER Make. Also this may be excessive some of the aforementioned may not need to come out. Using the Five provided screws insert them into the dash mount holes and rest the mount on the dash making sure none of the hardware for the ball mounts interfere with the dashboard.

Prior to my Toyota dealership replacing both of my driver vents B-2-B warranty I attached a metal binder clip like a glorified paperclip to the vent which gave it just enough weight to counter the climb to the top. One is to the left of the steering wheel and the other is to the right. It is off slightly.

With panel Removal Tool unclip Panel under AC controls and unplug. Remove the blend door actuator from the air distribution housing and disconnect the HVAC wire harness connector from the actuator. With Panel removal Tool unclip gauge Panel slightly just enough to pull Radio out Do Not Remove 2.

The portion that the latch goes into is a separate piece. Bolts under over glove box. Remove the bolt nut and number two brace.