2001 Toyota Tundra Ignition Lock Cylinder Replacement

This is a short video on how to remove and replace the key ignition lock cylinder on a 1998 Toyota Camry.

2001 toyota tundra ignition lock cylinder replacement. Secure the switch with its screw s. How do I remove the ignition key cylinder on a 2001 Toyota tundra AT 2WD V6 the key will turn one click to where the steering column is unlocked but no farther the release button on the bottom of the switch will not move. Turn the lock cylinder to the ACC position with the ignition key.

Heres how to remove the ignition cylinder lock. When the ignition lock cylinder for your Toyota Tundra becomes loose and disjointed the ability of your key to turn the cylinder may be. Unplug the negative battery cable.

Toyota Tundra 2001 Ignition Lock Cylinder by WVE. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing. Make sure both the lock cylinder and column lock are in the ACC position.

The Gift beating even Steamed touch children. Slide the cylinder into the lock housing until the stop tab engages the hole in the lock. If not they will replace the cylinder at the cost of 150 or so.

Step 2 remove 2 screws behind hood release lever and 2 bolts on lower left and right of trim panel under steering wheel panel then pops out. I replaced the key cylinder on my 2001 Toyota Tundra and now the truck will turn over and than shuts right back off unless I hold the key to the right a little bit. Withdraw the lock cylinder from the lock housing while depressing the stop tab.

The product was developed to stringent factory. Step 1 remove lower left corner trim piece just snaps out. Turn the lock cylinder into the Accessory position with the key and insert a small screwdriver into the hole at the bottom of the ignition switch casting.