2001 Toyota Tundra Rear Bumper Removal

The center portion has the same plastic tabs and two plastic hooks youll have to bend in a little behind the license plate.

2001 toyota tundra rear bumper removal. The tongue capacity of 500 lbs is the weight of the hitchball can take from gravity so you can drop 500 lbs onto the. Generation 1 Toyota Tundra rear bumper step pad. Toyota Tundra without Park Assist Sensors with Standard Bed 2001 Rear Step Bumper Assembly by K-Metal.

So is it pretty easy to do. You might have to move the 14 liner over a bit to fond them. Toyota Tundra without Park Assist Sensors with Standard Bed 2001 Rear Step Bumper Assembly by K-Metal.

Same quality as OE for less Direct replacement. Next take off the front mudflat thing. Schemes of fastening of front and rear bumpers.

Remove tail lamp four 8mm nut perside unplug wires. I am assuming you have the 5VZ-FE engine which can pull 4900 lbs SR5 or 4750 lbs Limited. It should be a 10mm.

This will soft the bumper so you push it out easily on the car. I saw a youtube video where this kid replaced his tundras bumper but only the cosmetic part of the bumper the outer shell so no the part that goes to the frame. All the same-as-original bumpers from K-Metal are a perfect option to go if you want to restore and maintain the original look of.

Remove black clips under tail lamps flat head screwdriver to pull center of the clip up slowly then remove the hole clip. Removing the bumper from a 2020 Toyota Tundra to fit the new CBI Bumper. -remove the cover of the bumper underneath and Unscrew two screws on each side twisted upside down-around the bottom part Unscrew the screws spun up-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves-remove the connector from the fog lamp if any-remove connector from the PDC if any.